View Single Post
  #358  
Old 12-12-2012, 09:39 PM
ericg's Avatar
ericg ericg is offline
LawnSite Senior Member
 
Join Date: Aug 2006
Location: New York
Posts: 512
Quote:
Originally Posted by BigFish View Post
I can tell ya this, the bottom trim tool has nothin to do with small engines!
I'm thinkin the middle set of specialty screw drivers don't either!
Nor did the long reach carb adj. screwdriver with the non slip tips!
Ok Fish, you got me.
The center picture is a set of Snap On tire valve tools. There is a threader for the outside thread on the valve stem where the cap goes. The other is a threader for the internal threads on a valve stem. The other two tools are a valve stem removal tool and a reamer. Although it is not for an engine, it is for the tires that are on landscaping equipment. There have been tools here like the tool that helps putting links on chains that has little to do with small engines. The panel puller is used to pull or straighten sheet metal where you have little access. Yes, it is mostly for autos but I have used it on small tractors.

Last edited by ericg; 12-12-2012 at 09:44 PM. Reason: Text
Reply With Quote
 
Page generated in 0.03831 seconds with 7 queries