View Single Post
  #16  
Old 12-13-2012, 11:23 AM
rjtlawncare rjtlawncare is offline
LawnSite Member
 
Join Date: Apr 2007
Location: CINCY OHIO
Posts: 69
Quote:
Originally Posted by piston slapper View Post
1...a few millimeters shouldn't harm anything...make sure the valve slides easily in the guide..
2..lap the valves..it should leave a dull area on the valve faces and seats..
You don't want to grind the valve stem. ...that's only done on non adjustable valvetrains..L head engines.
3...Make sure the block and head are clean and dry...Never grease a gasket..they'll never seal..
Thanks slapper I'm off to get this thing running. I hope it purrrrrrsssss
Reply With Quote
 
Page generated in 0.04011 seconds with 7 queries