View Single Post
Old 12-21-2012, 07:38 PM
Monroe74 Monroe74 is offline
LawnSite Senior Member
Join Date: Jan 2006
Location: south central PA
Posts: 321
Ford F-250, oil leak on the head gasket

As for installing the studs you dont install them into the block first. The four studs that have interference on the right you tie off so they dont stick thru the bottom. Then use an allen wrench to tighten then install the rest of your studs. On the left there are two studs that have interference that you would tie off and install the same way. It really isnt that hard
Do it better than the last Guy!
Reply With Quote
Page generated in 0.03639 seconds with 8 queries