View Single Post
  #21  
Old 01-04-2013, 08:56 PM
Breezmister's Avatar
Breezmister Breezmister is offline
LawnSite Bronze Member
 
Join Date: Jul 2007
Location: South Jersey
Posts: 1,188
Quote:
Originally Posted by ed2hess View Post
Coil replaced under warrant. I kinda have to agree but don't know where else to go. It passed vac test. The carb works on another unit that measured 90psi.
Here is another old trick. take the plug out, bring the piston up to tdc and, then pull on the rope until the piston is half way down. Without going pass the exhaust port.

Take a tea spoon of straight mix oil and pour it in the cylinder, let it sit for half an hour so that the oil will soak down around the piston and behind the rings.

Now this is the important part Take a shop rag or paper towel, with out blocking the spark plug hole cover it, turn it on it's side, give it a hard pull and get the extra oil out of the cylinder. (switch off)

Once this is done, put a new gaped plug
in and see if it will start. If it does, it will smoke really badly. Run it at WOT until the smoke/oil burns out of the muffler.

If this dosen't work, the only other thing I can think of is replace the rings with new, if you havn't already. As long as the cylinder is not scored. Any scratches, no matter how small, and it will never run.

Good Luck
__________________
.
Masters Degree in Thinking Out Side Of The Box,Graduate of the MacGyver Institute of Ingenuity

The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic

RTFM What a concept

Reply With Quote
 
Page generated in 0.03780 seconds with 7 queries