View Single Post
  #15  
Old 01-07-2013, 10:57 PM
Junior M's Avatar
Junior M Junior M is offline
LawnSite Fanatic
 
Join Date: Jun 2008
Location: South Carolina
Posts: 13,173
make sure you put a clause in there about the unknown of concrete.

Had a job very similar I got bit on, 8x16 pad. Maybe not quite 16ft long. Dug down on the edge was roughly 4inches thick. Showed up with the bobcat, couldn't get it to break into a manageable piece. So I went and got a saw. Cut as deep as I could, still wouldn't break.. Then I got my electric Bosch jackhammer on it.. Broke the edge off.. That took all day. Turned out about 2ft in they turned down and made it close to 8inches thick.

I didn't know and neither did the customer. I am just saying always expect the worse with concrete..
__________________
Southeastern Services


Quote:
Originally Posted by bobcat_ron View Post

Just run the god damn sh*t out of the machine and the hell with all the other crap, make money instead of worrying about crap that only accountants think about!
Reply With Quote
 
Page generated in 0.03498 seconds with 7 queries