Thread: d30 problem
View Single Post
  #5  
Old 01-17-2013, 06:22 PM
RigglePLC's Avatar
RigglePLC RigglePLC is offline
LawnSite Fanatic
 
Join Date: Jul 2006
Location: Grand Rapids MI
Posts: 9,321
Take it apart again--probably the diaphragm is not seated properly in the grooves, as suggested by Turfwerks. Clean the groove thoroughly. Rotate to pump to pull the diaphragm into the grooves...then hammer it into the groove with a small rubber hammer...just to be sure. Did you mean you were leaking oil or water? It is sometimes possible to install the diaphragm upside down--or--I mean, inside out
Reply With Quote
 
Page generated in 0.03635 seconds with 7 queries