View Single Post
Old 01-17-2013, 09:31 PM
djagusch djagusch is offline
LawnSite Gold Member
Join Date: Mar 2006
Location: MN
Posts: 3,937
Originally Posted by piston slapper View Post
Perhaps...if you knew what you were trying to might be able to properly crosshatch a cylinder..
Those cylinders look rough...with no particular pattern..they will definitely shorten the life of the new rings..

I could see it if you were building an engine for are building these engines for paying customers..
The worst part is that you think these pictures are good examples of proper engine work..
What's your opinion on a ball hone used on a power drill? Local dealer hear does it that way and looks decent when done.
Looking for blown Kawi 29HP DFI engine's fd791d, whole thing, intake, throttle body, and electronic's. PM me if you have something you would like to sell.
Page generated in 0.04469 seconds with 8 queries