View Single Post
Old 02-01-2013, 08:57 PM
LawnSite Bronze Member
Join Date: Mar 2003
Location: Maine
Posts: 1,146
Custom built Tilt bucket

Took 3 years but my custom built tilt bucket for my Kubota U35 is done. Started with a Cat 303.5 bucket I got off of Iron Planet for cheap, torched the ears and used them for my pivot point, found a cylinder online had my welder fab up and weld the plates and reinforce and came out pretty well, just need to limit the flow in the lines to slow it down and reroute the one line and put a piece of rubber over the ram and its good to go.

What I started with

final product:
Reply With Quote
Page generated in 0.03790 seconds with 8 queries