View Single Post
  #9  
Old 02-06-2013, 10:33 PM
pugs pugs is offline
LawnSite Silver Member
 
Join Date: Jun 2006
Location: Southwest of Chicago
Posts: 2,769
Quote:
Originally Posted by Restrorob View Post
If you have to go back into it, Mic your cylinder bores..... Did you check ring end gaps before re-assembly ?

Deglaze/re-crosshatch the bores ?

There is a 0.5" over-sized ring set you can get if the bores worn over standard but less than total over-sized reject......
Its 0.50mm over. They need to be used with the matching oversized pistons and the block needs to be bored. Its about 0.020" over
Reply With Quote
 
Page generated in 0.03170 seconds with 7 queries