View Single Post
  #16  
Old 02-08-2013, 04:55 PM
piston slapper's Avatar
piston slapper piston slapper is offline
LawnSite Platinum Member
 
Join Date: Mar 2010
Location: Tampa Fl
Posts: 4,027
Quote:
Originally Posted by Restrorob View Post
If you have to go back into it, Mic your cylinder bores..... Did you check ring end gaps before re-assembly ?

Deglaze/re-crosshatch the bores ?

There is a 0.5" over-sized ring set you can get if the bores worn over standard but less than total over-sized reject......
Any other questions,,,???
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough...
Do The Work
Reply With Quote
 
Page generated in 0.03496 seconds with 7 queries