View Single Post
  #3  
Old 02-09-2013, 08:24 PM
IRRITECH's Avatar
IRRITECH IRRITECH is offline
LawnSite Senior Member
 
Join Date: Dec 2003
Location: ATLANTA, GA
Posts: 931
Next, wire brush, sand (60 grit), grind the surfaces. If I can't get the loose paint off with the brush or paper I just grind. You can see some of the really tight areas with rust, I just do the best i can with them. This is not a factory finish. You can continue sanding with finer grit if you want to, the more prep the better the end result will be.
Attached Images
           
__________________
The reigning Mayor of Stupidville
Reply With Quote
 
Page generated in 0.04564 seconds with 8 queries