View Single Post
  #3  
Old 02-13-2013, 06:36 PM
nateturner nateturner is offline
LawnSite Member
 
Join Date: Dec 2010
Location: kimberly ID
Posts: 66
Quote:
Originally Posted by ericg View Post
There is a safety switch for the forward speed control that is either loose or requires replacement. On page 57 in the link below, you will see the switch, item #14. I would look at the switch to see if it is loose and if so, adjust it and tighten the screws. If the switch still acts up, replace it. The switch is normally open, so for diagnostic purposes only, you can disconnect the switch and try and start the mower to verify the condition. However, this is a safety and is required to be in place prior to starting the machine for mowing. In other words, do not leave it disconnected for any other reason than diagnostics.

http://www.walkermowers.com/manuals/...000-15_pub.pdf
Hey thanks for detailed help! I was guessing it was a switch but theres so many of them i didnt know where to begin. I will look into this switch tonight.
Reply With Quote
 
Page generated in 0.03774 seconds with 7 queries