Thread: flow charts
View Single Post
  #76  
Old 02-26-2013, 11:12 PM
Wet_Boots's Avatar
Wet_Boots Wet_Boots is online now
LawnSite Fanatic
 
Join Date: Mar 2005
Location: metro NYC
Posts: 39,554
Quote:
Originally Posted by woodlawnservice View Post
What are you reffering to as "split zone" piping? I assume I will have at least 1.5 mainline if not 2" then have 1.5" pgv valves. From there tee off and go 1" both ways... one side with 2 pgp and one side with 3. That's if I can get 40' of throw outta them
Posted via Mobile Device
"Split" means you're running pipe in two directions from the zone valve with each one carrying about half the zone's flow.

You will not get a reliable 40 feet from a PGP unless the nozzles are bigger than standard and the pressure is higher.

You would be better off not settling on any part of the system design until you get the details on a water well. You might be working with lower pressures and closer head spacings.
Reply With Quote
 
Page generated in 0.03405 seconds with 7 queries