View Single Post
  #331  
Old 03-01-2013, 11:27 PM
Ridin' Green Ridin' Green is offline
LawnSite Fanatic
 
Join Date: May 2011
Location: Michigan
Posts: 8,892
Quote:
Originally Posted by Mickhippy View Post
I see what you mean, and what your thinking but thats a kind of mod I really dont want to know about. Welding burns the paint so I reckon Id have to take pullies etc off to sand and repaint, with a miss matched coloured paint!
It would be up to Hustler to screw up one of there decks!
Appreciate the thought though!
Im understand you mate.

However, I don't like welding on a deck if I don't have to either, so I'm thinking that you could make it by using a piece of 3/16" angle iron 1 1/2" wide on one side X 3" or whatever you need to get close to the blades without hitting the sails on the highest lift blade you use. Then, all you would have to do is drill two holes and bolt it in. If it didn't work, touch up the holes with any paint you have and then install rubber grommets to keep them from rusting or the touch-up paint from chipping off.
__________________
Quote:
Originally Posted by Darryl G
I can also tell by looking back to see how they're hanging and often reach back and feel them to see how firm they are.
Reply With Quote
 
Page generated in 0.03223 seconds with 7 queries