View Single Post
  #8  
Old 03-06-2013, 09:35 AM
piston slapper's Avatar
piston slapper piston slapper is offline
LawnSite Platinum Member
 
Join Date: Mar 2010
Location: Tampa Fl
Posts: 4,019
Quote:
Originally Posted by dutch1 View Post
Just an added tip to Slapper's post that works for me--load the grooves of the tap or thread chaser with grease gun grease. The grease will pick up all or nearly all of the metal removed and prevent it from entering the cylinder. Follow up by blowing out the cylinder as a further precaution.
Good tip ...Dutch...
I have stuffed a piece of a shop towel in the hole before threading..
and dug it out when finished...but ..as you always say...results may vary..
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough...
Do The Work
Reply With Quote
 
Page generated in 0.05226 seconds with 7 queries