View Single Post
Old 03-07-2013, 11:25 PM
Restrorob's Avatar
Restrorob Restrorob is offline
LawnSite Fanatic
Join Date: Apr 2005
Location: Show'n my truck off !
Posts: 11,025
Originally Posted by piston slapper View Post
Any ideas.?????

I gotz one !!!

Cut a extra inch off 6" instead of 5", Weld a piece of say 2" flat bar on the inside of the deck..... 1" inside and 1" hanging out past your cut;

Doing this will seal the cut line for a smooth transition and reduce any clippings from getting stuck in the cut gap, Would also help reduce sand blasting the edge of the raise up piece.....

Originally Posted by piston slapper View Post
You never learn anything until you admit you don't know it all...
Originally Posted by MannsLawnService View Post
some times the man in my mirror isn't so smart...
"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
Reply With Quote
Page generated in 0.03709 seconds with 8 queries