View Single Post
  #1  
Old 03-08-2013, 12:31 PM
birddseedd birddseedd is offline
LawnSite Bronze Member
 
Join Date: Jan 2012
Location: Kalamazoo MI
Posts: 1,920
What to do to flush my hydro oil

My wheel motor went out, not from contaminates or anything, the shaft simply broke. So thankfully in this case replacing the pump is not needed. However if I do not get the system clean it will be necessary.

So here is my question. how do i get all the oil out and get the system clean.

I had to remove the wheel motor to move the mower, since then its been sitting. but its been sitting with the two hoses disconnected. I will start by removing the hoses and pouring new oil threw them. after this is done and I replace the old motor, how do i flush the whole system and replace all of the oil? I could remove the hoses and run the system but that will not get the oil out of the motor.

thanks for the help
Reply With Quote
 
Page generated in 0.03324 seconds with 7 queries