View Single Post
Old 03-15-2013, 11:34 PM
birddseedd birddseedd is offline
LawnSite Silver Member
Join Date: Jan 2012
Location: Kalamazoo MI
Posts: 2,114
Originally Posted by piston slapper View Post
Widen the gate..
Cut and move 14 uprights....all attatched with expanded metal..
Move the fenders..
Repaint the trailer..
No to mention the cost of the angle iron needed to do it right..
Much easier and quicker to hinge the discharge end of the deck..
Come to think of it the axle might not be wide enough. you could always remove the sides for the length of the mower and keep the big mower at the back. the gate woudl not really need widened only on the bottom or top where it latches to the trailer. your wheels need to be on the gate, not the width of the deck.

just an idea. for a time i pulled my mower on a flat bed till i got a wider trailer.
Reply With Quote
Page generated in 0.03778 seconds with 8 queries