View Single Post
  #21  
Old 04-02-2013, 12:59 PM
SoCalLandscapeMgmt SoCalLandscapeMgmt is offline
LawnSite Bronze Member
 
Join Date: Sep 2007
Location: So. Cal.
Posts: 1,506
Quote:
Originally Posted by Kiril View Post
There are also various waterproofing coatings that might be worth looking into.
http://www.techni-tool.com/237CH012

We used to use this on controllers. If you were really careful you could remove the board from the receiver, spray it with this stuff and the re-assemble. At the very least it would help to eliminate any shorting of the components that is being caused by the moisture that is getting inside of the remote.
Reply With Quote
 
Page generated in 0.03415 seconds with 7 queries