View Single Post
  #2  
Old 04-03-2013, 09:54 PM
hustlermidwest hustlermidwest is offline
Sponsor
 
Join Date: Sep 2012
Location: Chicago, Ill
Posts: 619
No special tool or press needed. Just take the biggest hammer you can find and place it where you wont use it. I would use wood or something soft when tapping in the bearings with a light hammer. Don't try to get them in with one shot, take your time and be smooth and all should be well. Don't forget your grease.

Brian O
Reply With Quote
 
Page generated in 0.03165 seconds with 7 queries