View Single Post
Old 04-21-2013, 10:43 AM
Restrorob's Avatar
Restrorob Restrorob is offline
LawnSite Fanatic
Join Date: Apr 2005
Location: Show'n my truck off !
Posts: 11,025
Originally Posted by piston slapper View Post
even run a separate wire from the case to ground

I agree with Slapper, Good ground is important..... If the mount screw holes are stripped remove the cover and drill out, Then mount the regulator with screws and nyloc nuts putting the screw heads inside, Add a 14ga wire to one of the regulator mount screws then run to a cover mount screw in the block......
Originally Posted by piston slapper View Post
You never learn anything until you admit you don't know it all...
Originally Posted by MannsLawnService View Post
some times the man in my mirror isn't so smart...
"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
Reply With Quote
Page generated in 0.03686 seconds with 8 queries