View Single Post
Old 04-21-2013, 10:38 AM
piston slapper's Avatar
piston slapper piston slapper is offline
LawnSite Platinum Member
Join Date: Mar 2010
Location: Tampa Fl
Posts: 4,213
Originally Posted by Restrorob View Post
I agree with Slapper, Good ground is important..... If the mount screw holes are stripped remove the cover and drill out, Then mount the regulator with screws and nyloc nuts putting the screw heads inside, Add a 14ga wire to one of the regulator mount screws then run to a cover mount screw in the block......
I have to agree with you agreeing with me...
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough...
Do The Work
Reply With Quote
Page generated in 0.04176 seconds with 8 queries