View Single Post
  #11  
Old 04-23-2013, 09:24 AM
WrightCommercial WrightCommercial is offline
Sponsor
 
Join Date: Apr 2008
Location: Frederick, MD
Posts: 491
kawakx125,

How the blade acts when spun will tell you if its the deck or spindle. If you line up the two blades and one is offset (1/8" higher), when you spin that blade if it changes (now an 1/8" lower) its relationship with the other blade then the spindle has a bent shaft. If when you spin it the relationship does not change then the deck is bent. We never ran a thru bolt spindle on the RH's due to the low belt system and deck cover clearance on the top of the spindle.

Best Regards
Wright Mfg.
Reply With Quote
 
Page generated in 0.03564 seconds with 7 queries