View Single Post
  #5  
Old 05-10-2013, 01:19 PM
Greg78's Avatar
Greg78 Greg78 is online now
LawnSite Bronze Member
 
Join Date: May 2008
Location: Southwest, FL
Posts: 1,842
Quote:
Originally Posted by ron mexico75 View Post
cannot see any pictures. Just some guesses; tire pressure is off, underside of deck needs to be scraped, blades might be sharp but are they balanced? Is the deck level? Not too sure other than that.
I don't see how unbalanced blades will leave a bad cut? I don't balance my blades perfectly I get them close. When I've been in a rush to get my acreage cut I've put fresh sharpened blades but not balanced on and went to town with no difference in cut quality.

If I had a new mower that wasn't cutting good I'd take it back to my dealer if I've already checked the obvious: tire pressure, caster spacers the same, blade spacers the same, blades sharp, spindles good, deck clean and rpm correct.
Reply With Quote
 
Page generated in 0.04725 seconds with 7 queries