View Single Post
  #2  
Old 05-16-2013, 08:53 PM
piston slapper's Avatar
piston slapper piston slapper is offline
LawnSite Platinum Member
 
Join Date: Mar 2010
Location: Tampa Fl
Posts: 4,020
Kenny...if solving a rubiks cube is easy for you...its a piece of cake...

The main thing you want to locate is the big rivet under the plastic covering of the outer tube..
That will tell you which direction the bearings go in...there are 2 vee grooves and a notch for the rivet on each of the sliding bearing..
They will only go 1 way...if you get them backwards they hangup on the rivet...
Inserting from the engine end...i believe it goes...spring...bushing...spring...bushing..short tube with bearing...snapring..
I usually push the parts in ..extending the shaft as i go..making sure the alum starshaft stays about a foot outside the tube you are feeding the parts into..
When you get the short tube on...tighten it....collapse the shaft in...install the snapring...
This lets you pull out the shaft and insert it into the clutchdrum...and slide on the engine..

Its a piece of cake...
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough...
Do The Work
Reply With Quote
 
Page generated in 0.03577 seconds with 7 queries