View Single Post
  #30  
Old 05-25-2013, 02:14 AM
1idejim's Avatar
1idejim 1idejim is online now
LawnSite Fanatic
 
Join Date: Jul 2009
Location: State of Jefferson
Posts: 6,853
Quote:
Originally Posted by Wet_Boots View Post
I was just replacing the fails then, and not taking resistance measurements on them, since they were headed for a landfill.

I replaced a newer W*M solenoid a week or so back, and I did check its resistance first ~ 30 ohms.
The W*M plastic thread measures 35 ohms and the brass thread measures 30 ohms right out of the box Shoes.

I might be doing something way wrong but i don't change out solenoids unless they measure short (below 10) or open (OL or 1)
Posted via Mobile Device
Reply With Quote
 
Page generated in 0.03462 seconds with 7 queries