Originally Posted by IXINRGIXI
Need to be converted from you wick type fuel pick up to a fuel line and filter at the end of it
Posted via Mobile Device
How bad is that to do? I assume I can just seal off the old port and drill and seal an new hole for the new line. Or should I just pull the felt out and hook up a new fuel line with a filter to the old fitting? I'm not afraid to modify it a bit if I have to, I'm looking for a functioning saw not an award winning restoration.
I really haven't had the time to dig into it too much other than just a rudimentary carb cleaning and filing the tank and pulling on it for a while, I'll know more when I get a chance to work on it, maybe i'll try running a fuel line from the inlet to the carb to my mixed gas tank as it has good suction.
It's not the equipment that makes a professional, it's the operator.
'99 Dodge Ram 2500 reg cab long bed
'91 JD Lx172 38"/ bagger
'11 JD X300 48"
22'' '66 Western Auto Wizard
21"push mower/w bagger
Stihl KM 90 w/trimmer,tiller, and hedge trimmer
MTD 3.5 HP edger
AgraFab 17 cb ft trailer
Precise-Fit lawn sweeper
"Never Give Up! Never Surrender!"