Thread: Melter question
View Single Post
  #2  
Old 07-13-2013, 06:12 PM
viper881 viper881 is offline
LawnSite Member
 
Join Date: Oct 2009
Location: Michigan
Posts: 132
The regulator adjusts your pressure of how much propane you are using/igniting. I usually keep mine around 10psi and turn it down once i get to the desired temp. If there is only a little rubber in there you have to remember that it heats from the bottom up. If all the rubber is on one side it would take longer then if you had the same amount of rubber already was heated up spreader out inside the melter.
Reply With Quote
 
Page generated in 0.03895 seconds with 7 queries