View Single Post
  #464  
Old 07-17-2013, 11:30 PM
gdguth's Avatar
gdguth gdguth is offline
LawnSite Senior Member
 
Join Date: Feb 2005
Location: Midwest
Posts: 390
I didn't want to read thru all the pages to this thread, but I just bought a exmark commercial 30 last week and maybe this has already been brought up. So far I like it a lot, but the one thing I noticed today was that when I put it at 3 inches, the back tire on the discharge side was rubbing (wheel rubbing on the deck). Has anyone else had this happen. It is not bad, but is just slightly rubbing and makes a noise if I am just pushing it around when it is shut off. I think maybe I twisted the wheel a little or something. It is fine at every other cut height. Very close to rubbing at 3.5 inches. Anyone have this issue.
Reply With Quote
 
Page generated in 0.03579 seconds with 7 queries