View Single Post
  #11  
Old 07-29-2013, 01:54 AM
Breezmister's Avatar
Breezmister Breezmister is offline
LawnSite Bronze Member
 
Join Date: Jul 2007
Location: South Jersey
Posts: 1,207
Quote:
Originally Posted by ed2hess View Post
The main reason I went this route is I had several used scag spindles that didn't cost me anything. You can get em from dealer often times.
Just a thought Ed, I understand about keeping cost down, useing what you have.....While doing my research I came across these old Bobcat spindles.

http://www.stens.com/Portal.aspx?CN=A2E0AB965F7D

Lower profile and a shorter spindle shaft, by about an inch, no cutting and no shimming.....for when you run out of those old Scag spindles.....
__________________
.
Masters Degree in Thinking Out Side Of The Box,Graduate of the MacGyver Institute of Ingenuity

The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic

RTFM What a concept

Reply With Quote
 
Page generated in 0.03408 seconds with 7 queries