View Single Post
  #655  
Old 07-29-2013, 01:40 PM
Ridin' Green Ridin' Green is offline
LawnSite Fanatic
 
Join Date: May 2011
Location: Michigan
Posts: 8,315
Quote:
Originally Posted by ProStreetCamaro View Post
The 52 must create more vacuum than the 60 because mine certainly wont try and lift thatch out of the lawn. I am starting to wonder if mine is actually turning the correct rpms. It is much smoother and quieter than my previous 460 was and low rpm would explain the easy rpm shifts and slight lack of power on hills.
PSC-
I bought one of these tach's that Greg78 mentioned earlier in this thread-
http://www.lawnsite.com/showpost.php...&postcount=616

I mounted it to my 950 and found it was running a little below specs, especially with the blades engaged. I adjusted it up so that now I am just about 3620-30 off load and just about 3580 on load, which is about 110 rpm's more than where it was at on load previously. I'm going to see if there's any difference in QOC over the next week of cutting. It was very easy to mount and I have it right between my choke and throttle knobs so that it is easy to see.
Reply With Quote
 
Page generated in 0.04500 seconds with 7 queries