View Single Post
  #1  
Old 07-29-2013, 03:55 PM
JohnnyRocker JohnnyRocker is offline
LawnSite Senior Member
 
Join Date: Jan 2007
Location: Charlotte, NC
Posts: 685
Raising Toro Grandstand to Remove Blades

hello good people!

So I have finally broken down and purchased my own impact wrench to make life easier. Today I used the method where you drive your front castors up on your trailer gate to get underneath to remove the blades. The only blade that I had enough clearance to remove was the center blade. The side ones were too close to the ground still. I tried several angles, etc. Any bright ideas would be great, besides buying one of those jacks. I am in search of a very cheap, temporary fix for now....if there is one. At least my middle blade is sharp! ha ha.

Reply With Quote
 
Page generated in 0.03587 seconds with 7 queries