View Single Post
Old 07-29-2013, 07:28 PM
ProStreetCamaro's Avatar
ProStreetCamaro ProStreetCamaro is offline
LawnSite Gold Member
Join Date: Apr 2004
Location: Gaithersburg Maryland
Posts: 3,874
Originally Posted by Ridin' Green View Post
I bought one of these tach's that Greg78 mentioned earlier in this thread-

I mounted it to my 950 and found it was running a little below specs, especially with the blades engaged. I adjusted it up so that now I am just about 3620-30 off load and just about 3580 on load, which is about 110 rpm's more than where it was at on load previously. I'm going to see if there's any difference in QOC over the next week of cutting. It was very easy to mount and I have it right between my choke and throttle knobs so that it is easy to see.

I am going to have to get me one of those and check this thing.
2013 Gravely 460Z 29EFI
2011 Gravely 36GR
2008 Gravely 160Z
2004 Gravely 34Z
1998 Lazer Z HP 48 (old faithful)
Reply With Quote
Page generated in 0.03487 seconds with 8 queries