Originally Posted by dboyd351
The lo screw is turned in and out until the trimmer will accelerate quickly and cleanly off idle. The high speed screw is set so it will rev out well.
The low screw is the idle circuit. Adjust it, so that it cleanly idles. You may need to bump up the idle a bit, while adjusting.
The high screw will pickup from idle all the way out. I hold the machine wide-open and adjust until it runs cleanly. Then, I double-check that it will cleanly accelerate.
I use 1-1/2 turns as a base.
Be sure your filter is clean, are using fresh gas, and are on a new plug.
1st Class Lawn Service
'14 Hustler X-ONE, 60", Kohler ECV749 EFI
'05 Hustler FasTrak, 42", Honda GXV530
'13 Toro Timemaster 30"
'02 Lawn Boy SilverPro 21"
Stihl BR600 blower
Stihl BG55 blower
Stihl KM55R string trimmer
Stihl KM55R Kombi system
Stihl MS180C chain saw
Echo GT-2000 trimmer
'14 Ariens Compact 24" Sno-Thro snowblower
'08 Troy Bilt Squall 2100 21" snowblower
'06 Chevrolet Silverado
'13 Bravo Star, 7'X12', V-nose