View Single Post
Old 08-25-2013, 08:44 PM
fatboynormmie's Avatar
fatboynormmie fatboynormmie is offline
LawnSite Senior Member
Join Date: Jul 2009
Location: balto md
Posts: 779
Hey Ferris I noticed the stock trailer frame looks like angle. I would have welded in some sq box tubing around the perimeter of the trailer frame to the angle under the box area.The hyd cyl places a lot of stress just as it's starting to pick the box up while it's loaded. Watch for fatigue on the angle as your box is most likely stronger then the trailer frame.

You can also use your trailer's front jack to help stabilize the frame when backing the mower in to dump just make sure you put it up before you drive off.
Reply With Quote
Page generated in 0.03264 seconds with 8 queries