View Single Post
  #10  
Old 09-01-2013, 02:08 PM
chip25521 chip25521 is offline
LawnSite Member
 
Join Date: Aug 2011
Location: Dayton, TN
Posts: 104
Quote:
Originally Posted by Ridin' Green View Post
Well then, remove those two baffle plates I mentioned in between blades at the rear. One bolt is all there is to remove to take them out. It makes a large difference in QOC, and discharge on my deck, and I get less buildup underneath too (though to be honest, I don't really get that much under it even when mowing right after a long rain as set up by the factory, but then again, mine is a 60").

I get a lot less buildup on top the deck or on me with those baffles removed. When I switch to the OEM wavy blades for fall, it almost totally eliminates the buildup on top of the deck, and they do a much better job mulching leaves and grass than the high lifts do, but still leave a good cut.
Ok, I'll try that. I get grass throw all over me sometimes.
Reply With Quote
 
Page generated in 0.03324 seconds with 7 queries