View Single Post
  #4  
Old 09-08-2013, 10:03 PM
mihomeowner mihomeowner is offline
LawnSite Member
 
Join Date: May 2013
Posts: 12
Quote:
Originally Posted by greenmonster304 View Post
If the zones are close to using the total output you might be able to adjust the pressure switch or re nozzle some heads. Or install cycle stop valve
I'm trying to figure out if the zones are using too much, or not enough water.

The I way I look at it, my pump is set from 30psi to 50psi. If a zone is making the pump cycle, it means the pump is shutting off (getting my system to 50psi). So the way to stop it from building that much pressure is to have more water flowing, so it doesn't reach 50psi. Is that correct logic?

So these zones that are making the pump cycle, could it be that not enough water is coming out?

When you say renozzle, are you talking about a higher flow rate nozzle?
Reply With Quote
 
Page generated in 0.03854 seconds with 7 queries