View Single Post
  #10  
Old 09-12-2013, 12:26 PM
mihomeowner mihomeowner is offline
LawnSite Member
 
Join Date: May 2013
Posts: 12
Quote:
Originally Posted by RAlmaroad View Post
Almost everyone on the coast has shallow well pumps for irrigation. When I install a well, a 40-60 pressure switch is used. All you have to do is to increase your cut off pressure higher (usually a few turns). Or as mentioned increase your outflow on the rotors or add another rotor. Set your timer to about a 5 minute delay between zones to let the motor windings cool.
Your saying a lot of people have a separate well for irrigation? I guess it makes sense. In my neighborhood in Michigan, I think everyone just has the main well for their house which also is for irrigation.

I might try to tweak up the pressure some off of 30-50psi. It makes sense that this would help the zones that are using too much water.

How do I increase the outflow of the rotors?

Thanks for help
Reply With Quote
 
Page generated in 0.03166 seconds with 7 queries