View Single Post
  #4  
Old 09-17-2013, 12:04 AM
gebby gebby is offline
LawnSite Senior Member
 
Join Date: Nov 2009
Location: COLUMBUS, OHIO
Posts: 678
Check to make sure that the pulley and the belt are both tight enough. My key on my pulley had loosened on me earlier this year. That pulley also runs the spreader. Check your nozzles for any blockage. If you have any type of filter(s) make sure they are also clean. Any lines kinked? Its something simple. Put it in neutral, sit still and pull the sprayer at full throttle, measure your width. It should be 11 ft. or close to it. I have a book that tells how much approximately that should come out. If you ask 10 different guys, I'll bet you get 10 different answers. Most guys adjust to their piece of equipment. Since the pump hasn't been used much, anything is possible. Just my opinion
Reply With Quote
 
Page generated in 0.03442 seconds with 7 queries