View Single Post
  #1  
Old 09-22-2013, 11:48 AM
TigerElectrical TigerElectrical is offline
LawnSite Member
 
Join Date: Sep 2013
Location: Northern Illinois
Posts: 14
Design, Wiring & Bulb Installation

As I mentioned in another thread I'm taking over an incomplete year-old installation of LED lighting. I haven't done LED before and have questions regarding best practices, acceptable practices and poor practices.

Is it not necessary to do hub wiring with LEDs to maintain an even voltage throughout the installation? This installation appears to be strung, if that's the term. The connections are made with wire nuts, above grade in one place. In line-voltage wiring a set-screw connection with shrink tube is required. And the bulbs were installed with what appears to be no-alox. I'm guessing that the fixture and bulb pin are plated steel (not aluminum) and copper grease might be a better material. But then what do I know?
Reply With Quote
 
Page generated in 0.04208 seconds with 7 queries