View Single Post
  #2  
Old 10-06-2013, 02:14 PM
1idejim's Avatar
1idejim 1idejim is online now
LawnSite Fanatic
 
Join Date: Jul 2009
Location: State of Jefferson
Posts: 7,033
Quote:
Originally Posted by bans25 View Post
SL1600 with one SLM4 and one SLM12 worked great for years, then went out. Found transformer was bad. Replaced transformer and unit powered for about 20 seconds, Second transformer went bad. Replaced the SL1600 with a new one, unit powered up for 5 seconds and went out. Saw that newer SL1600 has an in-line fuse after transformer. Pulled SLM modules out and swapped fuse, unit powers up fine. Put in old SLM4 module (no wires attached) and fuse blew again. Is it possible storm blew out the SLMx modules?? Has anyone experienced this?
I have to get a couple more SLMx modules to try to get this working.
I would measure the resistance of each station before going any further, that should of been the first course of action. If you are measuring under 10 ohms resistance on 1 or more stations you should begin a search for a direct short.
Reply With Quote
 
Page generated in 0.03435 seconds with 7 queries