View Single Post
  #11  
Old 10-13-2013, 07:20 PM
joee0914's Avatar
joee0914 joee0914 is offline
LawnSite Member
 
Join Date: Feb 2011
Location: Morris, New Jersey
Posts: 112
Thanks, for the replies and help so far.

I checked plate direction and air in system and neither thing seemed to work.

What I did do was remove the plate and reinstall it leaving the bolts just hand tight. Althought it let some fluid flow past the o-ring, I regained power to that wheel.

Could it be possible that when I re threaded the casing I went in on a slight angle which is binding up the charge pump when the plate is fully tightened to the casing?

I'm not really sure if this is even feasible but I'm not sure what else it could be at this point.
__________________
~High Mountain Landscaping, LLC~
Reply With Quote
 
Page generated in 0.04377 seconds with 7 queries