View Single Post
  #12  
Old 10-14-2013, 10:56 AM
Z'mnypit's Avatar
Z'mnypit Z'mnypit is offline
LawnSite Member
 
Join Date: Apr 2011
Posts: 40
Older thread but I just finished building my ripper setup for my TL130 Saturday. Tested it out Sunday and its perfect.. We have a few bare spot a disc wouldn't break up so I built this using inspiration from this thread. Worked like a champ.

For the mounting plate I used and old set of forks. Cut and notched the bottom using a torch then welded in a piece of 4x4x1/4in square tubing 5ft long. The rest I used 1/4in flat bar for re-enforcements and 2x3x1/4 rectangle tubing for the shank mounts



Reply With Quote
 
Page generated in 0.03228 seconds with 7 queries