View Single Post
  #29  
Old 02-11-2014, 02:08 PM
jmkr02's Avatar
jmkr02 jmkr02 is offline
LawnSite Member
 
Join Date: Jun 2004
Location: Dearborn, MI
Posts: 228
I would like to see data. same with equipment sales people can't tell me the average hours to expect out of a machine and they draw a blank then tell you it's all in how it is maintained. There are averages and there are outlieOrs. A thick blade may not cut as fast as a thin one because it is cutting more material. If the blade is thinner it has a greater chance of warping. There is give and take. Bevel, diamond offset, composition, and cooling relief I would think would make a difference. I want to believe cost equals better when I spend more but what works works. Some people need designer clothes some people need extra holes and a higher pricetag.
Posted via Mobile Device

Last edited by jmkr02; 02-11-2014 at 02:12 PM.
Reply With Quote
 
Page generated in 0.03931 seconds with 7 queries