View Single Post
  #47  
Old 02-18-2014, 01:31 PM
BigFish's Avatar
BigFish BigFish is offline
LawnSite Bronze Member
 
Join Date: Jul 2008
Location: chesapeake, va
Posts: 1,657
Quote:
Originally Posted by JRS Landscaping View Post
Well got new carb on and it runs a lot better. however it still surges unless i pull the choke ever so slightly. Checked main jet and its a 95# I'm almost at sea level. Anyone got any ideas, I'm at a loss. I set the choke so it was on ever so slightly in the off position and it runs normal. Rob would turning that limiting screw out solve this?
Did ya ever open up the main jet on the old carb as was suggested? If not, ya might wanna try reaming it out with a torch tip cleaner or jet drill. Use a loose fitting one and just roll the jet over the knurl/spirals. Ya don't wanna hog too much out.
Install it in yer new carb and see what happens.

You are running an air filter, right?
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!"

......AMF!
Reply With Quote
 
Page generated in 0.03495 seconds with 7 queries