Originally Posted by bcg
I don't, the well installers do. The relief is on top of the down pipe where that galvanized thread cap is in your picture. I'm not going to move it and risk burning up a pump, I figure the well guys put it there for a reason and if it's draining water, it's probably supposed to.
Think about it for a minute.
The relief valve is installed first, before the cycle stop valve and you posted earlier that
I use one that is installed outside the casing but it has to be the first thing on the line, before the pressure tank, pressure switch, etc.
So aren't you defeating the purpose of the valve?
I mean, I know it's working for you but it's prolly not working at it's best performance level.
Posted via Mobile Device