View Single Post
  #2  
Old 11-08-2003, 04:12 PM
vipermanz's Avatar
vipermanz vipermanz is offline
LawnSite Bronze Member
 
Join Date: Mar 2001
Location: Birmingham Alabama
Posts: 1,780
Aluminum is a difficult material to weld with, but with a lot of practice you can have it mastered with a 115v machine, you will have to use a machine with a shielding gas system and possibly have to change the drive rollers and wire liner heading towards the gun, As far a Tig goes, Yes it is somewhat easier but only because you can drop the amperage super low, another factor is also you may not need a filler metal with Tig.


Any questions Just Ask!!!!
__________________
<img src="http://img.photobucket.com/albums/v404/vipermanz/Newbanner.jpg" alt="Image hosted by Photobucket.com">
Check Out Weldingweb !!!
 
Page generated in 0.03905 seconds with 7 queries