View Single Post
  #8  
Old 07-15-2004, 01:55 PM
Redneck'n's Avatar
Redneck'n Redneck'n is offline
LawnSite Member
 
Join Date: May 2004
Location: Austin Texas
Posts: 31
if you put new blades on the machine.. when you have the blades on, turn the blades so the tips are next to each other.. they should be even with each other.. or really really close.. i think a 16th of an inch is about the most it can be off...
watch me try and make a picture here..haha..

should look like this:
__blade__ __blade__ __blade__

if it looks like this:
__blade-- __blade__ __blade--

then the deck is bent.. that is assuming the blades are new and are not bent.. it could also be the jackshaft bent.....
if i can find a better illustration of blade tips, i will post it...
good luck...
__________________
<0. less than negative
Reply With Quote
 
Page generated in 0.03835 seconds with 7 queries