Thread: Fast Rev B&S
View Single Post
  #2  
Old 10-29-2004, 07:11 AM
ducky1 ducky1 is offline
LawnSite Senior Member
 
Join Date: Oct 2002
Location: s.e. Kansas
Posts: 252
On a B&S motor to set the preload on a gov you open the throttle up wide open and which ever way the gov shaft turns, that is the way you need to turn the shaft after you loosen the clamp on the gov arm. If your engine did not do this before you cleaned the carb, you may have the linkages on wrong. Have not seen a gov go bonkers just by cleaning the carb.
__________________
ducky
Reply With Quote
 
Page generated in 0.03732 seconds with 7 queries