View Single Post
  #9  
Old 11-01-2004, 08:09 PM
Joe B J's Avatar
Joe B J Joe B J is offline
LawnSite Member
 
Join Date: Mar 2004
Location: Alabama
Posts: 37
What I would do is straighten the crank. Take trhe blade off and turn crank till you recognise the bend. Use a two pound hammer and straighten it back. I have used a lenght of pipe over the crank when it is bent very bad, and fine tune with the hammer. A lot of people may advise against this, but I have been doing it about thirty years with no ill effects.
Reply With Quote
 
Page generated in 0.03465 seconds with 7 queries